Decal Application

Please read through all steps first.

1. Make sure your surface is ready!

It should be clean, smooth and dust-free. Allow it to dry before continuing.

2. Separate the backing from the decal and transfer tape.

The transfer tape has blue lines on it. Keep transfer tape and decal and discard the backing.

3. Position the decal over (but not touching) your surface.

Once you like the position, carefully adhere the decal starting at the top and slowly lower it until it is fully touching your surface. Press on the transfer tape to keep in it position.

4. Adhere to the surface.

Using a credit card at a 45 degree angle, slowly move from the middle outward in all directions. Firmly and methodically, move in all directions, multiple times, with increasing pressure on each pass. After doing it multiple times, do it a few more just for good measure!

5. After you have pressed on the entire decal many, many times. . .

1. Remove the Transfer Tape. Do this step very slowly. Start at one corner and slowly pull the transfer tape off your surface. If any of the vinyl decal comes with it, place both back on your surface and reapply with your credit card many more times! Smooth out any leftover bubbles.